The downloadable PDF is a print of this page and carries all 16 OSHA HCS sections.
Last reviewed 2026-06-17 by Andre Taki, Chief Commercial Officer, DOT Hazmat–certified (49 CFR 172.704).
CAS number
14807-96-6
Structure
Structure · PubChem
Grade
Industrial
Signal word
Danger
Hazards
Health hazardH350
Section 1
Identification
Product Identifier
Talc Powder - White Colored Technical Grade
Grade
Industrial
CAS Number
14807-96-6
Manufacturer
Alliance Chemical 204 South Edmond Street, Taylor, TX 76574
Emergency Phone
Chemtel 1-800-255-3924 (24/7)
Recommended Use
Industrial / laboratory chemical. See Section 7.
Restrictions on Use
No restrictions identified beyond the conditions of safe use in Sections 7 and 8.
Section 2
Hazard Identification
Health hazard
Classification
Carcinogenicity, Category 1
Signal Word
Danger
Hazard Statements
H350May cause cancer
Precautionary Statements
P201Obtain special instructions before use.
P202Do not handle until all safety precautions have been read and understood.
P280Wear protective gloves, protective clothing, and eye/face protection.
P308+P313IF exposed or concerned: Get medical advice or attention.
P405Store locked up.
P501Dispose of contents and container in accordance with local, regional, national, and international regulations.
Classification, hazard (H) and precautionary (P) statements and pictograms per OSHA HCS 2024 (29 CFR 1910.1200, Appendices A–C), aligned with GHS Rev. 7.
Section 3
Composition / Information on Ingredients
Composition and information on ingredients
Component
CAS No.
Formula
Concentration
Talc
14807-96-6
Mg3Si4O10(OH)2
>=99% (w/w)
Concentrations are nominal; lot-specific values appear on the Certificate of Analysis. Components not contributing to classification are omitted.
Section 4
First-Aid Measures
Eyes
Rinse with plenty of water for at least 15 minutes. Remove contact lenses if present and easy to do. Continue rinsing. Seek medical attention immediately.
Skin
Immediately flush with plenty of water for at least 15 minutes while removing contaminated clothing. Wash with soap. Get medical attention immediately.
Inhalation
Move person to fresh air and keep comfortable for breathing. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. Get medical attention immediately.
Ingestion
Do Not Induce Vomiting! Never give anything by mouth to an unconscious person. If conscious, wash out mouth with water. Get medical attention immediately.
Most Important Symptoms and Effects
No specific symptoms are expected from the hazards identified in Section 2.
Immediate Medical Attention and Special Treatment
Treat symptomatically. Get medical attention if symptoms develop or persist.
Section 5
Fire-Fighting Measures
Suitable Extinguishing Media
Use water spray, alcohol-resistant foam, dry chemical, or CO2. Use measures appropriate to local circumstances.
Unsuitable Extinguishing Media
Do not use a solid water stream as it may scatter and spread fire.
Specific Hazards Arising from the Chemical
Containers may rupture when heated.
Protective Equipment
Wear self-contained breathing apparatus and full protective clothing.
Hazardous Combustion Products
May include carbon oxides and other toxic fumes. See Section 10.
Section 6
Accidental Release Measures
Personal Precautions
Use PPE as described in Section 8. Ensure adequate ventilation. Evacuate personnel to safe areas.
Environmental Precautions
Prevent leakage or spillage from entering drains, sewers, or waterways.
Containment & Cleanup
Absorb with inert material. Collect in appropriate waste container. Dispose per applicable regulations.
Section 7
Handling and Storage
Safe Handling
Use with adequate ventilation. Avoid contact with skin, eyes, and clothing. Wash thoroughly after handling. Keep container closed when not in use.
Safe Storage
Store in a cool, dry, well-ventilated area. Keep away from incompatible materials (see Section 10). Keep containers tightly closed.
Section 8
Exposure Controls / Personal Protection
Occupational Exposure Limits
Occupational exposure limits
Limit
Value
OSHA PEL
20 mppcf TWA
NIOSH REL
2 mg/m³ TWA (respirable)
IDLH
1000 mg/m³
Engineering Controls
Use adequate ventilation. Provide eyewash stations and quick-drench showers accessible to areas of use.
Eye/Face Protection
Wear chemical safety goggles or face shield.
Skin Protection
Wear chemical-resistant gloves and protective clothing.
Respiratory Protection
Use a NIOSH-approved air-purifying respirator with cartridges appropriate for the contaminant. For higher exposures or confined spaces, use supplied-air or a powered air-purifying respirator (PAPR).
Exposure limits sourced from NIOSH Pocket Guide and OSHA 29 CFR 1910.1000. Hazard classification from ECHA Classification and Labelling Inventory (CLP Annex VI).
Section 9
Physical & Chemical Properties
Appearance
Fine powder, soft texture
Odor
Odorless.
Odor Threshold
No data available
pH
8.5 - 10.0
Melting Point / Freezing Point
1700 to 1800 °F (NTP, 1992)
Boiling Point
1744 °C
Flash Point
No data available
Evaporation Rate
No data available
Flammability (solid, gas)
No data available
Upper/Lower Flammability or Explosive Limits
No data available
Vapor Pressure
0 mmHg at 68 °F Essentially (NTP, 1992)
Vapor Density
No data available
Relative Density
2.70 - 2.85
Solubility
less than 1 mg/mL at 70 °F (NTP, 1992)
Partition Coefficient (n-octanol/water)
No data available
Auto-ignition Temperature
No data available
Decomposition Temperature
No data available
Viscosity
No data available
Particle Characteristics
No data available
Form
Fine powder
Density
2.7 to 2.8 (NTP, 1992)
Values shown reflect product-specific canonical data. Lot-specific ranges may vary; see the Certificate of Analysis for the shipped lot.
Section 10
Stability and Reactivity
Reactivity
Not reactive under normal conditions of use and storage.
Chemical Stability
Stable under recommended storage conditions.
Possibility of Hazardous Reactions
None under normal processing conditions.
Conditions to Avoid
Heat, sparks, open flame, and incompatible materials.
May produce carbon oxides and other toxic fumes when heated to decomposition.
Section 11
Toxicological Information
See Section 2 for GHS hazard classification.
Likely Routes of Exposure
Inhalation, skin contact, eye contact, ingestion.
Symptoms
No specific symptoms are expected from the hazards identified in Section 2.
Delayed and Chronic Effects
Carcinogenicity: may cause or is suspected of causing cancer after long-term exposure (see the carcinogen classification below).
Numerical Measures of Toxicity
No data available
Carcinogen Classification
Carcinogen classification
Agency
Status
IARC
Group 2A — probably carcinogenic to humans (Talc; IARC agent: Talc, Vol. 42, Sup 7, 93, 136).
NTP
Not listed as carcinogen.
OSHA
No substance-specific standard in 29 CFR 1910 Subpart Z; classified as a carcinogen under the Hazard Communication Standard (29 CFR 1910.1200). See Section 2.
Scope: the IARC evaluation addressed talc not containing asbestos; the human evidence concerns perineal use of body powder.
Section 12
Ecological Information
Ecotoxicity
Data not available. Avoid release to the environment.
Persistence & Degradability
Not Available
Bioaccumulative Potential
Not Available
Mobility in Soil
Not Available
Section 13
Disposal Considerations
Dispose of contents/container in accordance with applicable federal, state, and local regulations. Do not dispose of into drains or waterways.
Section 14
Transport Information
Not regulated for transport under US DOT 49 CFR Subchapter C, IMDG, or IATA DGR.
Section 15
Regulatory Information
Regulatory inventory listings
Inventory / List
Status
California Proposition 65
Not listed
US EPA TSCA Active Inventory
Listed
EPCRA SARA 313 (TRI)
Not listed
SARA 311/312 hazard categories correspond to the GHS classification in Section 2. Data retrieved as of: California Proposition 65 2026-10-02; US EPA TSCA Active Inventory 2026-10-02; EPCRA SARA 313 (TRI) 2026-10-02.
Section 16
Other Information
Revision Date
Format
16-section format per OSHA HCS 2024 (29 CFR 1910.1200, Appendix D), aligned with GHS Rev. 7.
Disclaimer: The information provided in this Safety Data Sheet is correct to the best of our knowledge at the date of publication. It relates only to the specific product identified and does not relate to its use in combination with other materials. ALLIANCE CHEMICAL MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. ALLIANCE CHEMICAL DOES NOT ASSUME LIABILITY FOR LOSS, INJURY, DAMAGE, OR EXPENSE ARISING FROM THE HANDLING, STORAGE, USE, OR DISPOSAL OF THIS PRODUCT.
Alliance Chemical, 204 South Edmond Street, Taylor, TX 76574. Published by Alliance Chemical from first-party canonical product data. Our authority is hands-on chemical handling, DOT/GHS-compliant shipping, and government-registered distribution — not bench chemistry. This Safety Data Sheet is prepared from the regulatory data on file for this product.